Sindoh M612 - Page 191

185
- Tray2 Pickup DC motor
- Tray2 Transport motor
To do Tray2 motor test
M611/M616
M612/M617
1. Select Printer service in the diagnostic
mode.
2. Select Hardware test
3. Select T2 motor test.(Already entered in
Tray1 motor test mode and started to test)
4. Press [Back] to exit.
1. Select Printer service in the diagnostic
mode.
2. Press Next button at the lowr right side to
move to the next page.
3. Select Hardware test-T2 motor test
(Already entered in Tray1 motor test mode
and started to test)
4. Press EXIT to exit.
Once Tray2 motor test starts, Tray2 Pickup DC motor and Tray2 Transport motor is
simultaneously On and Tray2 Pickup DC motor automatically Off in 1 sec. and Tray2
Transport motor sequentially Off in 2 sec.
 T3 motor test (Tray3 motor test)
This test can be used to decide whether Pickup motor installed inside the Tray in the base
unit works properly, or not.
The following motor is available in the Tray3 motor test mode.
- Tray3 Pickup DC motor
- Tray3 Transport motor
To do Tray3 motor test
M611/M616
M612/M617
1. Select Printer service in the diagnostic
mode.
2. Select Hardware test
3. Select T3 motor test.(Already entered in
Tray1 motor test mode and started to test)
4. Press [Back] to exit.
1. Select Printer service in the diagnostic
mode.
2. Press Next button at the lowr right side to
move to the next page.
3. Select Hardware test-T3 motor test
(Already entered in Tray1 motor test mode