Singer 560 - Stability and Carriage Operation Issues; Ribber Arm and Yarn Changer Issues

CD
CD
If a stitch has dropped during knitting
only on the Knitter ...
1. Insert a One-Eye Transfer Tool into a stitch below the
dropped stitch and replace it into needle hook together
with loose yarn.
2. Slowly pull the needle out until the stitch is behind the
open latch leaving the loose yarn in the hook .
3. Push the needle back so the latch will close and the
stitch behind will slide over the hook reforming a stitch
as illustrated .
IN CASE A STITCH HAS DROPPED AND RUN DOWN
FOR SEVERAL ROWS:
1. Insert a Tappet into a stitch a few rows below the drop-
ped stitch from the side away from you . Unravel the
stitches down to the Tappet Tool.
Hint With the other hand, pull the fabric downwards.
This makes unravelling easier.
2. Push the Tappet Tool toward you so the stitch will be
behind the open latch. Catch the yarn crossing above
into the hook.
3. By pulling the Tappet Tool backwards, the latch will
close and the loose yarn will be trapped in the hook_
4. Continue pulling and the old stitch will slide down over
the closed latch forming a new stitch in the hook .
5. Repeat this operation up to the top .
6.
Place the top stitch onto the needle hook.
- 107 -