Singer 560 - Cast-On and Knitting Procedures

0
~
B
c
P CARRIAGE
In drive lace knitting, use P Carriage "A" without P Presser
liB".
-
In pile knitting, use P Carriage "A" with P Presser "B"
attached .
Place P Presser "B" underneath Arm "C" and secure with
fastening screw "0".
WITHOUT P PRESSER
Place P Carriage straight onto Knitter or Ribber Needle Bed
ensuring rail guide "A" fits correctly on rail "B" .
WITH P PRESSER ATTACHED
Place P Presser "A" first over Sinker Posts "B" thereafter
place rail guide "C" onto rail "0" .
On Knitter always start from the right side .
® Move P Carriage once (right-left).
Stitches will be behind latches and needles are aligned
in C position.
@ Move P Carriage twice (right-left-right).
Stitches have s lipped off needles.
On Ribber always start from the left side.
® Move P Carriage once (left-right).
Stitches will be behind latches and needles are aligned
in C position.
@ Move P Carriage twice (left ..... right-left).
Stitches have slipped off needles.
- 60 -