Singer 560 - WIDE RIB

CAST-ON FOR TIGHTER EDGE
Q
~
II
Ill--
<7
) ~
=rn o Br
.......
=
A
-
"
Q
"
=rn 0 rrr
~--------------- ~®~ --------------~
-4------ CD \,
,, \ \
(,~ 111111111111111111111111111111 ·))
\ \ I
\ I
, __________ ,® _____ ..,../
r\
.l t
a:Gf~~ 11i~
:~ [I ~
~a~~~-w
~ ~ l~~::: 1)~ ,...___
To make the east-on edge of the fabric tighter, when knit-
ting with thinner yarn, set the Carriages as instructed in the
operation table, but operate them following the procedure
set forth below :-
0- 1 Set machine controls for the initial row and have
Carriage on the right side .
0- 2 Arrange needles, and knit the initial row from the
right to the left.
0 - 3 Suspend Cast-on Comb with Weights.
Insert Cast-on Comb so that its teeth '~"confront
with Knitter Sinker Posts "8" as illustrated.
• Disconnect Ribber Carriage and move it twice accross
the needles to drop stitches on Ribber needles .
If Cast-on Comb is suspended incorrectly, it will drop
onto the floor.
• Connect Ribber Carriage and knit one row with same
Carriage settings.
0-4
As required in operation table, knit subsequent 3 rows.
CAST-ON FOR Tl GHTER EDGE IS COMPLETED.
When the garment has been completed, pull the yarn of the
initial row of east-on towards the direction opposite to its
yarn end slightly before pressing it with a steam iron so
that the stitches on the initial row align neatly.
After pressing the edge has been finished, pull out the yarn
completely in the same direction as above.
-=
~
~
- 69 -