Singer 560 - Pattern Design on Card

10-20 cm.
T
Type of knitting
Stockinet
(medium yarn)
Kl. Pl. rib
(medium yarn)
2-Colour A.T.
~
...
...
~
4-Colour A.T.
'<JJIV
...
...
~
, . -~ J;jf ' .. 7.,
If the end stitches are not stable or if
the Carriage is heavy to operate ...
Check the following points.
• Is the yarn coming out freely from the inside of yarn
ball. ( IGr P.2)
• Is the yarn threaded into the Auto-Tension correctly.
( !Gr P.8)
• Is the machine lubricated properly. ( IGr P.114)
If the Ribber Arm does not fit on the
Standard Carriage properly ...
1. Check to see if the top of the Standard Carriage is down
to close.
The top of the Carriage must be down.
2. Check the setting of the Cam Lever. It should be set at
"0" before mounting the Ribber Arm, never at F (KNIT-
IN) or L (PUNCH LACE).
If you knit with the Knitter only as
the Ribber is connected ...
1. Disconnect Ribber Arm and Carriage from Knitter Car-
riage.
2. Lower Ribber to its fullest extent by pushing down
Drop Levers twice.
3. Install Knitter Arm and start knitting.
To use the Lace Carriage as the Ribber is connected, refer
to page 35, for special cares to take.
If you use 4-Colour Auto- Tension for
knitting other than double jacquard ...
The tension springs of the Four-colour Auto-Tension are
stronger than those on the Two-colour Auto-Tension.
If you use the Four-Colour Auto-Tension for normal knit-
tings, set the Tension Dial and Stitch Dial as follows.
Tension Diai .................... .... ... Refer to page 8 .
Stitch Diai .............................. Use 1 number larger.
- 111 -