Singer 560 - Preparation for Pattern Knitting

PREPARATION FOR PATTERN KNITTING
A micro-computer is incorporated in the machine and takes
on full control of needle selection for pattern knitting.
SETTING UP THE MACHINE FOR PATTERN
KNITTING
CD Take off the Auto-Tension from the top of the Yarn
Rod. Fit the Curl Cord Support Block on top of the
Yarn Rod, and bring it down till it stops .
Set the Auto-Tension on the Yarn Rod again .
(2) Connect the plug at the end of the straight cord to the
socket on the machine so as the triangle marks cor-
respond.
(3) Connect the plug at the end of the Curl Cord to the
socket on the Carriage so as the triangle marks cor-
respond .
® Connect the plug on the Power Cord to an A.C. mains
supply .
@ Connect the inlet cord from the Transformer to the
machine.
®
- 19 -