Singer 560 - If Incorrectly Knitted

0
~
\
dj
f,lll
~
· Cb
./~
~ ~
fP
0
0
11
!
~
:I:
]
~
-
If incorrectly knitted ...
Have the Carriage outside of the fabric (working needles)
and remove the yarn from the Yarn Feeder.
Refer to page 101, and unravel the incorrectly knitted rows.
IN CASE OF USING PATTERN BUTTON 3:
If an odd number of rows are unravelled, unravel an extra
row making the total unravelled rows an even number.
IN CASE OF DOUBLE JACQUARD:
If the yarn end is at the left side unravel an additional row
so that it comes to the right side.
Replace the yarn into the Yarn Feeder, or if the Carriage
is at the side opposite the yarn, pass it to the side with the
yarn following the instruction given for each knitting.
IN CASE OF USING THE STANDARD CARRIAGE:
Push the Release Lever and lift up the Handle, then move
the Carriage to the side of the yarn.
IN CASE OF USING THE LACE CARRIAGE: '
Set the Cam Lever to "N", and pass the Carriage to the
side with the yarn.
IN CASE 0 F USING THE RIBBER :
(1) Disconnect Ribber Carriage from Arm and move it
to yarn side while tilting Carriage.
(2) Remove the Ribber Arm from the Standard Carriage .
(3) Lift up the Handle of the Carriage, and move the
Carriage to the side of the yarn .
(4) Connect the Ribber Carriage and Arm to the Standard
Carriage.
If the Row Counter is in use, return it by the same number
as unravelled.
If the Knit Contour is in use, return the Pattern Paper as
many rows as unravelled referring to page 21 of the
"Knitting Manual", and start knitting.
But if a Pattern Card is used together, refer to the next
page.
- 10 8 -