Singer 560 - Pattern and Stitch Type Possibilities

If the Holder Buttons of the Yarn
Changer were erroneously operated ...
Correct positions of the Holders while knitting are as below.
® ..... 1 Holder (Knitting yarn)
(]) .. . .. 1 Holder (Yarn to be changed next)
@ .... 2 Holders (Resting yarns)
In case of more than two Holders positioned in ®.
( 1) Push Feeding Lever to the left, and the Holders in
® move back into (]).
(2) Push Release Button, and all the Holders align in @.
(3) Push the Holder Button to set it into (J) which should
hold the yarn in Yarn Feeder .
(4) Push Feeding Lever to the left to push the Holder
from CD into ® .
(5) Push Holder Button holding the yarn to be changed
next, from@ into CD .
Then rearrange yarns on the Holders .
In case of more than two Holders positioned in (]), follow
the above steps (2) through (5) .
To repack Yarn Changer, set all the Holders at @ by
operating as instructed in the above steps (1)-(2).
If the Yarn Changer got stuck on the
Needle Bed ...
Pull out Needle Retainer toward right by 2-3cm. using
Hook Tool, then loosen Securing Wheel until it stops .
- 11 2 -