Singer 560 - Single Motif Knitting

SINGLE MOTIF
• 0 • 0
0 0 0 0
lllrt j llttl l ltt t t j ttltt j t ttt t j ttttl t rtrl j ttt ! t l trlll j trttr l
6 12 18 24 30 42 48 S4 60
36
stockinet
motif
stockinet
A single pattern in Knit-in (Fair Isle) can be knitted at any
position on the fabric.
The sample is knitted with the Pattern No.5-(14).
Before knitting patterns in this stitch type, follow the
Preparatory Steps given on pages 19-22, and additional
cares instructed below.
BEFORE KNITTING THE PATTERN
Set the Point Cams at both end needles of the width of a
unit of the pattern and place the Needle-1 Cam to confront
with the left Point Cam as shown in the diagram.
As this pattern is of 36 stitch wide pattern, the Point Cams
must demarcate 36 needles within them.
When knitting in single motif pattern, the Button 1 must
remain in "UP" position (Its left light is on.).
-x
~ Q QQ
I oo I c I • I • I • I ~1
• 0 0 0 0 0
Open the latches of the 4th, 5th and 6th needles on the
outsides of the knitting needles.
Insert the Yarn Separator under those needles on both
sides as far as they go.
Set the Carriage controls.
Cam Lever .... ..... .......... F (KNIT-IN)
Russel Lever .... ...... .. .. ... ll (both)
Tuck Lever .. .... .. ...... .. .. . O (both)
Weaving Knob .............. o (both)
- 24 -