Singer 560 - Page 16

Open the Yarn Feeder Gate, and take the yarn from the
Yarn Clip, and pull it down to the Yarn Feeder.
Guide the yarn into the Yarn Feeder, and holding the yarn
end with your hand, close the Gate.
Pull the yarn down through the Yarn Feeder, and guide it
under the Arm and over the needles in D position .
Check the tension on the yarn, and adjust it by pulling the
yarn back towards the yarn ball at the back of the Yarn
Rod .
If the yarn is threaded through the Auto- Tension incor-
reclty,
it will not have tension on it, and the east-on will
be a failure.
Or,
if the yarn has been slackened, pull the yarn back
toward the yarn ball
at the back of the Yarn Rod.
- 12 -