Singer 560 - Page 35

To start pattern knitting, follow the procedure below.
Take the thick yarn from the Clip on the Yarn Rod, and
place it inside the Weaving Yarn Holder on the leading side
of the Carriage.
Holding the weaving yarn under the Arm, push the first
knitting needle into D position, and then move the Carriage
to the other side.
Before knitting the next row, bring the weaving yarn to the
other side, and place it inside the Weaving Yarn Holder.
Guide the weaving yarn under the Holder and then under
the Arm to the other side of the Carriage.
At this step, push the Carriage in the direction it moved,
the weaving yarn becomes free from the Brushes under the
Arm easily.
Place the weaving yarn inside the Holder on the leading
side of the Carriage.
Push the first needle, and move the Carriage to the other
side of the needle bed.
Repeat in the same manner, placing the weaving yarn into
the Holder on the leading side before knitting the next row.
To do partial knitting in the weaving pattern, push the
first knitting needle into C position.
- 31 -