Singer 560 - Important Notes for Lace Knitting

\
.._ I r
=
•
•
1
2
~
Q
Q
l~lcl
..,
I
-
I
•
0 0
•
i
~~~~~,~~
~
II
3
4
5
6
Q
Q
Q o)
•1~1-·1
"1111.
I
0 0
0
0
~
~
n ~ @
[
Align the needles in B position.
Set the Needle-1 Cam.
Set the Point Cams at the position to mark off two working
needles at both edges .
Set the Carriage controls .
Cam Lever .......... .. ... .... . O (STOCKINET)
Stitch Dial. ... .. . ... .. ..... . .. (refer to page 36)
Cast on using the Ravel Cord and continue to knit in
stockinet about 30 rows ending at the right side of the
fabric.
Hang the Claw Weights, and the Comb Weights on them
as shown.
Push "DOWN" the Button 2.
The other Pattern Buttons must be in "UP" position .
J
Pattern Buttons 1, 3, 4, 5, 6 can not be used for the lace
knitting.
Push "OFF" the Inspection Button.
PREPARATORY STEPS FOR KNITTING LACE STITCH
PATTERN HAS BEEN COMPLETED .
YOU ARE READY TO KNIT THE LACE PATTERNS .
. -·--- ... - ... _. ... _. ... _. ... ._. ,.. ___ _ __ __ __ ... ..... ... ._ .... _. ... __ ... _ ... __ ... __ ... _ ... _____ ..... _ ... _ .... _ ..... __ __ ..... _ ... _ ..... _ .... _ .... _ ..... _ ..... _ ..... ... ..... _ ... _ .. _ ..... _ ... _ ... _ ..... _ ..... _ ... _ ... _.
• •
~ ~
4 IMPORTANT TO NOTE: 4
• •
: • When knitting in lace stitch pattern, the Pattern Button 2 must be in "DOWN" position in principle, and the :
: other Buttons must be in "UP" position. :
~ ~
• •
~ ~
• •
: • Set the Point Cams at the position to exclude two working' needles at both edges . :
~ ~
• •
~ ~
• •
: • Be sure to have the Carriage at the right side of the working needles befor e starting to knit lace stitch patterns, :
: to correspond with the knitting direction arrow marks on the Patt e rn Card . :
~ ~
• •
~ - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - ~
- 42 -