8 Positioning patients Sirona Dental Systems GmbH
8.4 MultiMotion headrest C3
+
59 06 404 D 3390
42 D 3390.201.01.18.02
8.4 MultiMotion headrest
Adjustment to patient's height
The headrest can be adjusted to the patient's height by
pulling out or pushing in the headrest extension. This
adjustment is usually required at the beginning of treat-
ment!
Before positioning the patient on the headrest, make
sure that the head support has been optimally adjusted
to the patient's height. This simplifies all subsequent
work with the MultiMotion considerably, since readjust-
ment to the patient's height can thus be omitted when
changing over from mandibular to maxillary treatment.
The MultiMotion enables you to adjust the patient's head
in a way that optimally supports viewing of areas of the
mouth which are difficult to access.
Adjustment of hyperextension
Mandibular position
The mandibular position can be set by pulling the
operating handle (A). The anatomical movement of the
arched extension keeps the patient's head in the sup-
port.
✔ Pull the headrest out of the guide by pulling
handle A.
Tip
: You can reduce the adjustment noise by pressing
release A.
To Next Page
Loading...
