Sirona C3 Plus - Mode: Maintenance and Service

11 Basic treatment center settings in the Mode dialog Sirona Dental Systems GmbH
11.2 Mode: NACL PUMP OFF or ON for instrument holder .. C3
+
59 06 404 D 3390
66 D 3390.201.01.18.02
11.2 Mode: NACL PUMP OFF or ON for instrument holder ..
Saline solution for the desired burr instrument
or the SIROSONIC L scaler (swivel arm 2 − 5)
Here you can assign the NaCl pump to a certain instru-
ment using the
– / + keys.
For preparation of the NaCl pump, see page 57.
IMPORTANT
NACL appears on the display in the instrument dialog of
the instrument to which the NaCl pump has been as-
signed.
IMPORTANT
If you want to assign the NaCl pump to the SIROSONIC L
scaler, always select holder 5, regardless of the scaler’s
position in the instrument rack.
11.3 Mode: MAINTENANCE
Display of the next maintenance due date
This dialog displays the number of days until the next
maintenance date. You should have maintenance per-
formed by your service engineer at least once annually.
The instrument running time is indicated in minutes in
the lower right-hand corner of the display (for service
engineers only).
As soon as the next maintenance date is less than
30 days away, the maintenance prompt appears each
time the unit is switched on. The message disappears
after an instrument is removed.
11.4 Mode: SERVICEONLYSTART − STOP
For service engineers only!
Mode
–
+
A
NACL – PUMP
OFF
NACL – PUMP
OFF
A
NACL – PUMP
ON FOR HANGER 2
NACL – PUMP
ON FOR HANGER 2
A
MAINTENANCE
360 8
MAINTENANCE
360 8
Mode
–
+
A
SERVICE ONLY
START – STOP
SERVICE ONLY
START – STOP