3. Enter the IP address of the communication unit in the address bar and press the enter key.
☑ The user interface opens.
4. To change the language, select the desired language in the field Language.
5. Enter the password in the field Password.
6. Select the button [Login].
12.8.2 Logging Out of the User Interface
Always log out from the user interface when you have finished your work. If you only close the web browser, you will
not be logged out. If the user interface is left idle for 15minutes, you will be logged out automatically.
Procedure:
• Select the button [Logout].
12.8.3 Accessing the Parameter Overview
1. Log into the user interface as an installer.
2. Select Data > Devices.
3. Select the desired device from the list.
4. Select the tab Parameters.
12.8.4 Saving Parameter Changes
Requirement:
☐ You must be logged in on the user interface.
Procedure:
1. Change the respective parameter via the field Value.
2. To adopt this value for all devices of the same type and with the same firmware version, activate the box Save
for all devices of this device type.
3. Select the button [Save].
☑ The communication unit adjusts the required value on the device(s).
4. Select the button [OK].
12 Periodic Actions
SMA Solar Technology AG
System ManualMVPS22JP-SH-en-11178
To Next Page
Loading...
