C
ONFIGURING
THE
S
WITCH
3-108
Setting Broadcast Storm Thresholds
Broadcast storms may occur when a device on your network is
malfunctioning, or if application programs are not well designed or
properly configured. If there is too much broadcast traffic on your
network, performance can be severely degraded or everything can come to
complete halt.
You can protect your network from broadcast storms by setting a
threshold for broadcast traffic. Any broadcast packets exceeding the
specified threshold will then be dropped.
Command Usage
• Broadcast Storm Control is enabled by default.
• Broadcast control does not effect IP multicast traffic.
• The specified threshold applies to all ports on the switch.
Command Attributes
• Port
7
– Port number.
• Trunk
8
– Trunk number.
• Type – Indicates the port type. (100BASE-TX, 1000BASE-T, or SFP)
• Threshold – Threshold as percentage of port bandwidth.
(Range: 64-95232000 octets per second; Default: 32000)
• Protect Status – Shows whether or not broadcast storm control has
been enabled. (Default: Enabled)
• Trunk
7
– Shows if a port is a trunk member.
7. Port Broadcast Control.
8. Trunk Broadcast Control.
To Next Page
Loading...
