SMC Networks 6726AL2 - Map Access-List Mac; Table 4-37 Egress Queue Priority Mapping

A CCESS C ONTROL L IST C OMMANDS
4-133
Related Commands
mac access-group (4-132)
map access-list mac
This command sets the output queue for packets matching an ACL rule.
The specified CoS value is only used to map the matching packet to an
output queue; it is not written to the packet itself. Use the no form to
remove the CoS mapping.
Syntax
[no] map access-list mac acl_name cos cos-value
• acl_name – Name of the ACL. (Maximum length: 16 characters)
• cos-value – CoS value. (Range: 0-7)
Default Setting
None
Command Mode
Interface Configuration (Ethernet)
Command Usage
• You must configure an ACL mask before you can map CoS values to
the rule.
• A packet matching a rule within the specified ACL is mapped to one
of the output queues as shown below.
Example
Table 4-37 Egress Queue Priority Mapping
Queue 0123
Priority
1,2 0,3 4,5 6,7
Console(config)#int eth 1/5
Console(config-if)#map access-list mac jerry cos 0
Console(config-if)#