SMC Networks 6726AL2 - Figure 3-15 System Logs

B ASIC C ONFIGURATION
3-35
Web – Click System, Log, System Logs. Specify System Log Status, set the
level of event messages to be logged to RAM and flash memory, then click
Apply
.
Figure 3-15 System Logs
CLI – Enable system logging and then specify the level of messages to be
logged to RAM and flash memory. Use the show logging command to
display the current settings.
Console(config)#logging on 4-59
Console(config)#logging history ram 0 4-60
Console(config)#end
Console#show logging flash 4-64
Syslog logging: Enabled
History logging in FLASH: level emergencies
Console#