EasyManuals Logo
Home>SMC Networks>Network Router>6726AL2

SMC Networks 6726AL2 User Manual

SMC Networks 6726AL2
516 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #69 background imageLoading...
Page #69 background image
B
ASIC
C
ONFIGURATION
3-19
CLI – Specify the management interface, IP address and default gateway.
Using DHCP/BOOTP
If your network provides DHCP/BOOTP services, you can configure the
switch to be dynamically configured by these services.
Web Click System, IP Configuration. Specify the VLAN to which the
management station is attached, set the IP Address Mode to DHCP or
BOOTP. Click Apply to save your changes. Then click Restart DHCP to
immediately request a new address. Note that the switch will also broadcast
a request for IP configuration settings on each power reset.
Figure 3-7 DHCP IP Configuration
Note: If you lose your management connection, use a console
connection and enter “show ip interface” to determine the new
switch address.
Console#config
Console(config)#interface vlan 1 4-144
Console(config-if)#ip address 10.1.0.254 255.255.255.0 4-249
Console(config-if)#exit
Console(config)#ip default-gateway 192.168.1.254 4-252
Console(config)#

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the SMC Networks 6726AL2 and is the answer not in the manual?

SMC Networks 6726AL2 Specifications

General IconGeneral
BrandSMC Networks
Model6726AL2
CategoryNetwork Router
LanguageEnglish

Related product manuals