VLAN C
OMMANDS
4-213
switchport mode private-vlan
Use this command to set the private VLAN mode for an interface. Use the
no form to restore the default setting.
Syntax
switchport mode private-vlan {host | promiscuous}
no switchport mode private-vlan
• host – This port type can subsequently be assigned to a community
or isolated VLAN.
• promiscuous – This port type can communicate with all other
promiscuous ports in the same primary VLAN, as well as with all
the ports in the associated secondary VLANs.
Default Setting
Normal VLAN
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• To assign a promiscuous port to a primary VLAN, use the switchport
private-vlan mapping command. To assign a host port to a
community VLAN, use the private-vlan host association
command.
• To assign a promiscuous port or host port to an isolated VLAN, use
the switchport private-vlan isolated command.
Example
Console(config)#interface ethernet 1/2
Console(config-if)#switchport mode private-vlan promiscuous
Console(config-if)#exit
Console(config)#interface ethernet 1/3
Console(config-if)#switchport mode private-vlan host
Console(config-if)#
To Next Page
Loading...
Need help?
General
