SMC Networks 6726AL2 - Dot1 X Timeout Quiet-Period; Dot1 X Timeout Re-Authperiod

C OMMAND L INE I NTERFACE
4-112
Example
dot1x timeout quiet-period
This command sets the time that a switch port waits after the Max Request
Count has been exceeded before attempting to acquire a new client. Use
the no form to reset the default.
Syntax
dot1x timeout quiet-period seconds
no dot1x timeout quiet-period
seconds - The number of seconds. (Range: 1-65535)
Default
60 seconds
Command Mode
Interface Configuration
Example
dot1x timeout re-authperiod
This command sets the time period after which a connected client must be
re-authenticated.
Syntax
dot1x timeout re-authperiod seconds
no dot1x timeout re-authperiod
seconds - The number of seconds. (Range: 1-65535)
Default
3600 seconds
Console(config)#interface eth 1/2
Console(config-if)#dot1x re-authentication
Console(config-if)#
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout quiet-period 350
Console(config-if)#