S
YSTEM
M
ANAGEMENT
C
OMMANDS
4-83
show system
This command displays system information.
Default Setting
None
Command Mode
Normal Exec, Privileged Exec
Command Usage
• For a description of the items shown by this command, refer to
“Displaying System Information” on page -11.
• The POST results should all display “PASS.” If any POST test
indicates “FAIL,” contact your distributor for assistance.
Example
Console#show system
System description: TigerSwitch 10/100 6726AL2
System OID string: 1.3.6.1.4.1.202.20.46
System information
System Up time: 3 hours, 0 minutes, and 7.18 seconds
System Name: [NONE]
System Location: [NONE]
System Contact: [NONE]
MAC address: 00-30-F1-D3-26-00
Web server: enabled
Web server port: 80
Web secure server: enabled
Web secure server port: 443
Telnet server : enable
Telnet port : 23
Jumbo Frame : Disabled
POST result
DUMMY Test 1.................PASS
UART LOOP BACK Test..........PASS
DRAM Test....................PASS
Timer Test...................PASS
Switch Int Loopback test.....PASS
Done All Pass.
Console#
To Next Page
Loading...
Need help?
General
