Snom D712 - Changing the Settings on the Phone and Turning on Call Forwarding

56
D712/710 User Manual Using the Phone
Changing the settings on the phone and turning on call forwarding
If there is more than active identity on the phone, select the identity you want the setting to be applied
to if it is not the one marked as the outgoing identity by the preceding arrow . If you want to have call
forwarding settings for more than one identity, complete the below steps for one identity, return to the
idle screen, select another identity, and repeat the steps.
Forward all Forward when busy Forward after timeout
Press
on idle screen to select identity if more than one is available and if necessary
Press
Settin Settin Settin
Press
2 Call Features 2 Call Features 2 Call Features
Press
1 Call Forwarding 1 Call Forwarding 1 Call Forwarding
Press
1 Forward All
2 When Busy
3 On Timeout
Press
2 Target 2 Target 2 Target
Type phone number phone number phone number
Press
Press - -
3 Time
Type - - number of seconds
Press - -
Press
1 Activate 1 Activate 1 Activate
The setting will change to "1
Activate", indicating that call forwarding is now active. Press for
two seconds to return to the idle screen.
Forwarding when busy or after timeout:
Forwarding all calls:
Note: When there is more than active identity, the information in the status line and the
status info menu is that of the current outgoing identity indicated by the preceding .
The
symbol in place of the phone symbol indicates that forwarding of all calls for the identity
is activated. If there is no other status message with a higher priority, the status line shows the
extension, telephone, mailbox, or cell phone number that all incoming calls for the identity are being
forwarded to. If there is a status message with a higher priority, you can find the destination of the
forwarded calls in the status infos via the Settings menu > 6 Information > 1 Status info. For more
information on status messages see "Appendix 2 - Status Messages" on page 90.
Forwarding when busy and On timeout are indicated in the status bar which can display only
one message at a time. When both are active at the same time, only "Forward when busy" will be