Snom D712 - Appendix 2 - Status Messages

90
D712/710 User Manual Appendix 2
Appendix 2 - Status Messages
Whenever there is a current message concerning the status of the phone, the function key
Info
will
be available. Press the function key (or
Settin
> 6 Information > 1 Status Info) to open the "Status
info" screen. Additionally, some status messages will also be displayed in the status bar; if there is
more than one current message, the one with the highest priority will be shown. The messages in
descending order of priority:
Status message Definition
SW  A firmware update is available
Reboot required  Reboot required, for example to have settings changes
take eect
SIP disabled ,² The phone cannot make calls due to license problems
Error  An error occurred
Low memory  Disk space full
Remote directory is too big  The remote directory is too big to be imported
Not Registered: <account> ,² The specified identity/account is not registered
Waiting for <name/number> to be
available ²
Waiting for call completion to busy or currently
unavailable number
<account> is now available ² The dialed number is not busy anymore or is now
available
Forward when Busy: <name/number> Call forwarding is on. When your phone is busy,
incoming calls will be forwarded to the phone number
indicated
Forward after Timeout: <name/number> Call forwarding is on. When an incoming call is not
picked up within the set number of seconds, the call
will be forwarded to the phone number indicated
Forward all: <name/number> ² Forwarding of all incoming calls is on. All incoming
calls will be forwarded to the phone number indicated.
Contacting NTP server Network Time Protocol (NTP) is a protocol for
synchronizing clocks over data network. If the
connection is interrupted, the phone will not be able to
display the correct time.
NTP server unreachable 
HTTP Password not set  No HTTP password has been set
Admin Password not set  No Admin password has been set
Keyboard locked ² Only numbers designated as emergency numbers can
be dialled
DND active ² Do not Disturb mode is activated
You have messages There are spoken messages on the mailbox
You have new messages New (messages on the mailbox)
Old messages Old (messages on the mailbox)
Missed: <number> The number of calls you missed since the last time
you checked the list of missed calls or turned o the
missed call indication
 The function key
Info
will be blinking
² The message cannot be deleted from the "Status Info" screen