Snom D712 - Call Completion; Call Waiting

78
D712/710 User Manual Customizing the Phone Settings
Turning call forwarding off
1. Web interface > Configuration Identity # > Features tab > Call Forwarding.
2. Click "O" after the forwarding event ("Always", "Busy", "Timeout").
3. Click on Apply and Save.
Call completion
On Snom phones call completion means that when a called number is busy or not available, your
phone will call you back as soon as the dialed number is not busy anymore or available again. The
factory default setting is "o". See "Call completion" on page 44 on how to use this feature.
Note: This function depends on whether it is available in your network or not.
Changing the setting to turn it on:
On the phone
1. Press
Settin
> 2 Call Features > 2 Outgoing Calls.
2. Press
to active the function and change "4 Call Completion" to "4 Call Completion".
Alternative method: Scroll to "4
Call Completion" and press to active the function and
change "4
Call Completion" to "4 Call Completion".
3. Press
briefly to return to the previous menu; press for 2 seconds to return to the idle screen.
On the web interface
1. Web interface > Advanced > Behavior tab > Phone Behavior > Call Completion.
2. Click On.
3. Click on Apply and Save.
Call waiting
Default setting: When in a call, another call coming in is announced visually in the status line and
acoustically by a double beep. See "Call waiting" on page 53 on how to use this feature. Available
settings:
◦ On: Visual and acoustic announcement of calls waiting
◦ Visual only: Visual announcement of calls waiting in the status line
◦ Ringer: Acoustic announcement by double beeps
◦ O: No announcement; callers hear the busy signal
On the phone's web user interface, call waiting is set independently for each identity. If you use the
phone to change the setting, it will apply to the current outgoing identity.