Snom D712 - Page 97

97
D712/710 User Manual Appendix 4
Directory Internal phone directory
DND Turning "Do not disturb" function (DND) on an o. When mapped to a function
key with an LED, the LED will light up when DND is turned on.
Favorites Favorites list
Forward all All incoming calls will be forwarded to another extension or an external phone
number. After turning call forwarding on with this key, the display will prompt
you to enter - or confirm/change a previously entered - forwarding number.
Help FW versions lower than 8: Phone's IP address, MAC address, and firmware
version.
FW 8 and higher: Phone's IP address and the URI to Snom Wiki. IP address, MAC
address, and firmware version can be found in Settings > 6 Information >
2 System Information.
Hold Placing the active call on hold
LDAP Directory Allows the user to look up a remote directory while dialing. Once set, this
pressed key will open up the Direcory Search window. If LDAP is setup,
corresponding matching entries as returned by the sever will be shown. If LDAP
is not used and and presence_lookup_number setting is turned on, the contact
matches will be shown. The default edit mode is alphanumeric in this state.
Logo Identities Caution: This option will delete all account settings!
Usage: Mainly useful for call centers with frequently changing users.
Menu Calling up the settings menu of the phone
Missed Calls Missed call history list
Monitor Calls
(not available on
Snom 300)
When the phone has been programmed to monitor extensions and do/allow call
pickup, a key can be mapped to show the list of monitored extensions and do
call pickup from the monitor.
FW v8.7.2 and higher: The list will show only active extensions (i.e., busy or
ringing). When there is no activity on any monitored extensions, the list is empty.
Mute Mutes/unmutes the microphone (handset, speakerphone, headset) during active
call
Next Outgoing ID Selecting the next identity as the outgoing identity
Presence State Providing access to a list where the Presence state of each registered SIP
Identity can be defined (online, oine, busy, invisible).
Prev. Outgoing ID Selecting the previous identity as the outgoing identity
Reboot Rebooting the phone
Record The phone does not record the voice streams at all; they must be recorded on
the PBX or other external device. Pressed during a call, the key informs the
PBX to start and stop the recording of the audio stream on the PBX. While the
call is being recorded, the recording symbol
will either blink on the display
or be displayed, in red , in the status line, depending on the phone type; if the
function key has an LED, the LED will be lit throughout the recording. Please be
advised that you must respect the legal restrictions of your country for recording
calls with or without the participants' knowledge and permission.
Redial Dialed call history list (last call at the top)