Snom M900 - Page 55

55
v1.02
Admin and Installation Guide M900 Description of Settings
Setting Description
Enable automatic prefix Disabled: No automatic prefix added.
Enabled: The base station adds the leading digit defined in Set prefix for
outgoing calls.
Enabled+fallthrough on * and #: Enables detection of * or # at the first digit
of a dialed number. In case of detection, the base station will not add the
leading digit defined in in Set prefix for outgoing calls to the dialed number.
Examples, leading digit is defined as 0:
1: number dialed on handset *1234 - > number sent to pbx *1234
2: number dialed on handset #1234 - > number sent to pbx #1234
3: number dialed on handset 1234 - > number sent to pbx 01234
Default: Disabled.
Set maximum digits of
internal numbers
This setting is used to detect internal numbers. No prefix number will be
added to a dialed internal number.
Default: 0.
Set prefix for outgoing calls Prefix number for the enabled automatic prefix feature.
Permitted values: 1 to 9999.
Default: Empty.
Configuration
Configuration server address DNS or IP address of server providing configuration file to base station.
Default: Empty. Permitted values: IP address or URL.
Filename Default: Empty.
Text messaging
Text messaging Disable/enable messaging via server, if provided by third-party service.
Enable without server: Allow handsets to send messages to other handsets
supporting messaging.
Default: Disabled.
Text messaging & alarm
server
Permitted values: IP address or URL.
Default: Empty.
Text messaging port Port number of message server.
Default: 1300.
Text messaging keepalive (m) Intervals in minutes between keepalive messages. Permitted values: Positive
integers.
Default: 30.
Text messaging response (s) Frequency in seconds of response timeouts.
Permitted values: Positive integers.
Default: 30.
Text messaging TTL Text messaging time to live in seconds.
Permitted values: Positive integers.
Default: 0.
Terminal
Keep Alive (m): If other than 0, the handset sends an (emergencyLocationMsg) containing the
RSSI measurements with the interval in minutes specified in this setting.
Permitted values: Positive integer.
Default: 0
Auto Stop Alarm: Needs to be enabled to be able to use Auto stop alarm Delay
Default: Disabled.
Auto Stop Alarm Delay (s) Handsets automatically stop alarm announcement (emergencySms) after the
number of seconds specified in this setting.
Default: 30.