Sonicware LIVEN Texture Lab - System Settings: Knob Behavior; Knob Movement Behavior Selection

System settings
77
Setting knob movement behavior
1
Press
+ to set whether or not latching is used for knob op-
eration.
Latching
Jump
When a knob is moved, the pa-
rameter changes immediately.
Latch
The knob does not a󱐯ect the
parameter value until its posi-
tion reaches that value. Then,
the value follows the knob.
• When set to Latch, the dots on the display will be animated to
show how much the knob position and parameter value di󱐯ers
to the left or right.
The dots will appear to ow to the left when the parameter
value is lower than the knob position and to the right when
the value is higher than the position. The ow will be faster for
higher values.