Sonos CONNECT:AMP Product Guide

Product Guide
2-4
• Repeat to install the other speaker wires.
• If your speakers have banana connectors, you can insert the plugs directly into the banana jacks on the back of the
CONNECT:AMP instead.
2. Attach the power cord and plug into a wall outlet — make sure the Voltage Switch on the back of the CONNECT:AMP is
set to the proper position for your country before applying power.
The Mute button indicator and the Status indicator will begin to flash. (If this Sonos component was previously connected to
another Sonos system, the Status indicator may light solid white instead.)
Connect a SONOS CONNECT...
To a home theater or amplifier
1. Choose one of the following options:
• If you have digital inputs on your home theater or amplifier, you can use either a TOSLINK® optical audio cable or a 
digital coaxial cable to connect the CONNECT’s digital audio output to the digital input on the receiver.
• If you have analog inputs on your home theater or amplifier, use a standard RCA audio cable to connect a CONNECT’s
analog audio output to the audio inputs on the receiver.
2. Select the proper input channel on the receiver.
3. After you finish setting up your Sonos system, go to "Line-out" on page 2-13 to adjust the volume settings.

Sonos CONNECT:AMP Specifications

General

Audio decoders	Dolby Digital
Amplifier class	D
Frequency range	22 - 20000 Hz
RMS rated power	110 W
Built-in crossover	Yes
Crossover frequency	80 Hz
Audio output channels	2.1 channels
Peak power per channel	55 W
Signal-to-Noise Ratio (SNR)	- dB
Total Harmonic Distortion (THD)	0.02 %
Purpose	Home
Material	Aluminum
Product color	White
Connectivity technology	Wired
Audio (L/R) out	2
Headphone outputs	1
Headphone connectivity	3.5 mm
Speakers connectivity type	Banana connector/Binding posts
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 40 °C
AC input voltage	110-240 V
AC input frequency	50 - 60 Hz

Weight and Dimensions

Depth	207 mm
Width	185 mm
Height	89 mm
Weight	2300 g