EasyManuals Logo

Sonos CONNECT:AMP Product Guide

Sonos CONNECT:AMP
105 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
Product Guide
vi
Regulation Information
Europe
SONOS declares that this product herewith complies with the requirements of the EMC Directive 2004/108/EC, the Low Voltage Directive
2006/95/EC and the R&TTE Directive 1999/5/EC when installed and used in accordance with the manufacturer's instructions. A copy of
the full Declaration of Conformance may be obtained at
www.sonos.com/support/policies.
Europa
SONOS erklärt hiermit, dass dieses Produkt den Anforderungen der EMV-Richtlinie 2004/108/EC, der Niederspannungsrichtlinie 2006/
95/EC und der R&TTE-Richtlinie 1999/5/EC entspricht, sofern es den Anweisungen des Herstellers gemäß installiert und verwendet wird.
Die vollständige Konformitätserklärung finden Sie unter www.sonos.com/support/policies.
Europe
SONOS certifie que ce produit est conforme aux exigences de la directive CEM 2004/108/EC, de la directive basse tension 2006/95/EC et
de la directive 1999/5/EC sur les équipements hertziens et les équipements terminaux de télécommunications, sous réserve d'une
installation et d'une utilisation conformes aux instructions en vigueur du fabricant. Une copie complète de la Déclaration de conformité
est disponible sur le site www.sonos.com/support/policies.
Attention In France, operation is limited to indoor use within the band 2.454-2.4835 GHz.
(Attention. En France, l’utilisation en intérieur est limitée à la bande de fréquences 2,454-2,4835 GHz.)
USA
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
All SONOS devices have in-product antennas. Users cannot reorient or relocate the receiving antenna without modifying the prod-
uct.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Caution: Modifications not expressly approved by the manufacturer may void the user's authority to operate the equipment under FCC
rules.
Canada
This Class B digital apparatus complies with Canadian ICES-003 and RSS-210. Operation is subject to the following two conditions: (1)
this device may not cause interference, and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.
The installer of this radio equipment must ensure that the product is located such that it does not emit RF field in excess of Health
Canada limits for the general population; consult Safety Code 6, obtainable from Health Canada’s Web site
www.hc-sc.gc.ca/rpb. As
mentioned before, the installer cannot control the antenna orientation. However, they could place the complete product in a way that
causes the problem mentioned above.
The device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel
mobile satellite systems.
Be advised that high-power radars are allocated as primary users (i.e. priority users) of the bands 5250-5350 MHz and 5650-5850 MHz
and that these radars could cause interference and/or damage to LE-LAN devices.

Table of Contents

Other manuals for Sonos CONNECT:AMP

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sonos CONNECT:AMP and is the answer not in the manual?

Sonos CONNECT:AMP Specifications

General IconGeneral
Audio decodersDolby Digital
Amplifier classD
Frequency range22 - 20000 Hz
RMS rated power110 W
Built-in crossoverYes
Crossover frequency80 Hz
Audio output channels2.1 channels
Peak power per channel55 W
Signal-to-Noise Ratio (SNR)- dB
Total Harmonic Distortion (THD)0.02 %
PurposeHome
MaterialAluminum
Product colorWhite
Connectivity technologyWired
Audio (L/R) out2
Headphone outputs1
Headphone connectivity3.5 mm
Speakers connectivity typeBanana connector/Binding posts
Storage temperature (T-T)-20 - 70 °C
Operating temperature (T-T)0 - 40 °C
AC input voltage110-240 V
AC input frequency50 - 60 Hz
Weight and Dimensions IconWeight and Dimensions
Depth207 mm
Width185 mm
Height89 mm
Weight2300 g

Related product manuals