Sony DCR-PC350 - Page 203

DV MECHANICAL ADJUSTMENT MANUAL VII
HELP
Lead-free solder
Wire type: diameter 0.6
∅
Temperature of the soldering iron tip: 350 ° C
Contacting time of soldering iron tip: within 2 sec.
• Be careful not to create the
hollow soldering, Br,
and there must be no lacking of parts.
• Be careful not to crash the
grip jog to the TG1 guide.
Two solderings
Motor holder block
assy (Loading)
FP-467
flexible board
Screw
(M1.4
× 2.0)
FP-468
flexible board
MIC terminal
(MIC902)
Five solderings
LED (D901)
Two
solderings
FP-468 flexible board
Eight soldering
s
• Be careful not to create the
hollow soldering, Br, and there
must be no lacking of parts.
• Be careful not to melt the detent
of the holder.
• Be careful not to melt the END cover.
• Be careful not to break the terminals
due to attaching the soldering iron too
long time.
Lead-free solder
Wire type :
∅ 0.6
Temperature of the : 320 ° C
soldering iron tip
Contacting time of : within 2 sec.
soldering iron tip
Use the rubber finger tip cover
Lead-free solder
Wire type
Soldering iron
Soldering iron tip
Temperature of the
soldering iron tip
Contacting time of
soldering iron tip
:
∅ 0.6
: 941 made by Hakko
: T1-1BC
: 300
± 10 ° C
: within 2 sec
Rubber finger tip protection
cover must be used.
Lead-free solder
Wire type: diameter
∅ 0.6
Soldering iron: 941 made by Hakko
Soldering iron tip: T1-1BC
Temperature of the soldering iron tip: 300
± 10 ° C
Contacting time of soldering iron tip: within 2 sec.
LED (D901)
Direction of the terminal
is specified.
FP-468 flexible board
Soldering (1)