2-11
DSR-2000/2000P
2-9-2. Front Panel Setting
[Control Panel]
(1) VIDEO INPUT select switch setting : COMPOSITE ; Ordinary video signal
S VIDEO ; Y/C separation type S Video signal
Y-R, B ; Component signal (Betacam)
SDI ; Component digital signal
SDTI/i.LINK ; DV compressed digital signal
(2) AUDIO INPUT SELECT : Analog/Digital (AES/EBU)/SDI
[SUB sidiary Control Panel]
(1) CHARACTER : Selects either the character information is superimposed in the
video signal or not.
(2) CONTROL PANEL : Selects the status of the control panel when operating this unit.
(3) REC INHIBIT : Inhibits recording on a tape.
(4) KEY INHIBIT : Disables operation of the buttons specified on the upper/lower
control panels.
(5) PROCESS CONTROL : Selects the control method and setting of the built-in digital
video processor.
(6) INT/EXT-PRESET/REGEN : Selects internal time code/external time code, and preset the
built-in time code generator.
(7) FREE RUN/REC RUN : Selects synchronous operation of the built-in time code
generator.
(8) DF/NDF : Selects the synchronous operation of the time code generator
and the counter.
(9) VITC : Sets ON to record the VITC generates in the built-in time code
generator.
(10)TC SELECT : Selects the time code displayed on the time counter display
block.
(11)VIDEO : Adjusts the output level of the video signal.
(12)SET UP : Adjusts the setup level.
(13)CHROMA : Adjusts the output level of the chroma signal.
(14)Y/C DELAY : Adjusts the amount of the Y/C delay.
(15)CHROMA PHASE : Adjusts the chroma phase (the relative phase with the burst
signal).
(16)SYNC : Adjusts the sync phase of the output signal.
(17)SC : Adjusts the phase of the subcarrier.
2-9. Installation Setup and Adjustment
To Next Page
Loading...
