1-1. DSR-2000
Table of Contents
2
Table of Contents
For customers in the USA
This equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own
expense.
You are cautioned that any changes or modifications not
expressly approved in this manual could void your authority
to operate this equipment.
The shielded interface cable recommended in this manual
must be used with this equipment in order to comply with the
limits for a digital device pursuant to Subpart B of Part 15 of
FCC Rules.
Caution
Television programs, films, video tapes and other materials
may be copyrighted.
Unauthorized recording of such material may be contrary to
the provisions of the copyright laws.
For the customers in Europe (DSR-2000P only)
This product with the CE marking complies with both the
EMC Directive (89/336/EEC) and the Low Voltage Directive
(73/23/EEC) issued by the Commission of the European
Community.
Compliance with these directives implies conformity to the
following European standards:
• EN60065: Product Safety
• EN55103-1: Electromagnetic Interference (Emission)
• EN55103-2: Electromagnetic Susceptibility (Immunity)
This product is intended for use in the following
Electromagnetic Environment(s):
E1 (residential), E2 (commercial and light industrial), E3
(urban outdoors) and E4 (controlled EMC environment, ex.
TV studio).
Owner’s Record
The model and serial numbers are located in the rear.
Record these numbers in the spaces provided below. Refer
to them whenever you call upon your Sony dealer regarding
this product.
Model No.
Serial No.
WARNING
To prevent fire or shock hazard, do not
expose the unit to rain or moisture.
This symbol is intended to alert the user to the
presence of uninsulated “dangerous voltage”
within the product’s enclosure that may be of
sufficient magnitude to constitute a risk of
electric shock to persons.
This symbol is intended to alert the user to the
presence of important operating and
maintenance (servicing) instructions in the
literature accompanying the appliance.
Table of Contents
3
Table of Contents
Chapter 1
Overview
Features............................................................................. 7
System Configuration .................................................... 11
Location and Function of Parts..................................... 12
Upper Control Panel.............................................................13
Lower Control Panel ............................................................16
Subsidiary Control Panel .....................................................25
Connector Panel ...................................................................28
Usable Cassettes ............................................................ 33
Inserting and Ejecting Cassettes ..........................................34
Chapter 2
Setting/Displaying
Time Data and Text
Information
Displaying Time Data and Unit’s Operating Status—
Superimposing Text Information ............................ 35
Setting Time Code and User Bits .................................. 39
Synchronizing the Internal Time Code Generator With an
External Signal—External Lock .....................................42
Chapter 3
Recording and
Playback
Recording ........................................................................ 45
Preparations for Recording ..................................................45
Recording Time Code and User Bit Values..........................47
Recording Operation ............................................................48
Playback .......................................................................... 49
Preparations for Playback ....................................................49
Playback Operation ..............................................................50
Dynamic Motion Control (DMC) Playback.........................55
Synchronous Playback .........................................................59
Digitally Dubbing Signals in DVCAM Format
(Optional DSBK-190 Required When Using i.LINK
Interface) ...........................................................................
61
To Next Page
Loading...
