4-2
DSR-2000/2000P
Detection : Checks that switch S101 on
the SV-212 board is set to ON.
Operation after detection : None
Display : The alarm is displayed until
any key is pressed.
Detection : Checks that the FACTORY
USE item of the Setup menu is
changed.
Operation after detection : None
Display : The alarm is displayed until
any key is pressed.
ALARM
THE UN I T I S I N
ADJUSTMENT MODE.
SET THE SW I TCHES OF S101
ON THE SV BOARD TO OFF.
ALARM
SELECT I ONS OF THE SETUP
MENU’S FACTORY USE
I TEMS HAVE BEEN CHANGED.
SET THESE I TEMS TO
FACTORY PRESET VALUES.
4-1. Alarm Display
To Next Page
Loading...
