51
2-8. CN-4132 Board
Preparation
1. Remove the top cover. (Refer to “2-2. Top Cover”.)
2. Remove the optical multi fiber cable. (Refer to “2-7. Optical Multi Fiber Cable”.)
Procedure
1. Disconnect the fine-wire coaxial cable from the connector (CN001) on the CN-4132 board.
2. Remove the two screws, and then remove the CN-4132 board.
3. Install the removed parts by reversing the steps of removal.
Rear side
PSW
3 x 8
CN-4132 board
CN001
Hole
Hole
Fine-wire coaxial cable
Bosses
To Next Page
Loading...
