Sony HDCE-TX30 - Page 80

76
MODE
Screen display
Description
Item
Setting Value
Description
MEDIA CLOCK DIRECT
－
Set the Media Clock Direct value to be sent using the SAP protocol for each IP
Audio stream. When a long-distance system is built, a network transmission
delay is generated. Therefore, streams may be discarded due to delay
restrictions depending on receivers of other vendors. (Example: 2 ms or less
delay in the AES67 mode of Dante)
To avoid this problem, adjust this setting value according to the transmission
delay time.
AUDIO
-682.666 to 682.645 [ms],
0.000
Set the Media Clock Direct value of the IP Audio stream.
HD TRUNK AUDIO
-682.666 to 682.645 [ms],
0.000
Set the Media Clock Direct value of the IP HD Trunk Audio stream.
INTERCOM
-682.666 to 682.645 [ms],
0.000
Set the Media Clock Direct value of the IP Intercom stream.
IP LOOPBACK
EXEC
This function simply checks input and output of the ST2110 stream
independently.
Directly connect the LAN1 and LAN2 connectors with an SMF cable, and then
make the following settings in advance.
• SYSTEM CONFIG menu > GENLOCK page > GENLOCK: SD
• NETWORK menu > IP LIVE page > IP LIVE SYSTEM MANAGER
PORT: DISABLE
• NETWORK menu > NMOS page > PORT: DISABLE
After that, when EXEC is executed, the multicast address of input streams is
automatically set so that the ST2110 output streams are received.
This makes it possible to monitor the return output video signals on the
viewfinder of the camera and monitor output audio signals on the front panel.
Note
When this function is executed, the existing multicast address setting is
overwritten.
<MODE> ?S06 TOP
MEDIA CLOCK DIRECT
AUDIO : 0.000ms
HD TRUNK AUDIO : 0.000ms
INTERCOM : 0.000ms
TEST OUT : IP RETURN
IP LOOPBACK : EXEC