Sony LY51 - Page 33

130
English
0 Current value store setting
This function lets you recall the current value at the time the power was turned off when the power is turned on again.
!¡ A/B phase output setting
This sets the output signal when the optional expansion unit LZ51-H is connected. When not using the LZ51-H, setting is
unnecessary.
Initial value
“STr” menu setting is
necessary. (For AUTO input, set
the number in the seventh digit
of the second input screen.)
Regenerate the current
value at the time the
power was turned off
when the power is turned
on again?
For individual input:
Not stored
For AUTO input:
• • • • • • 2 •
Setting unnecessary
Initial value
“Ab.F” menu setting is
necessary. (For AUTO input, set
the number in the eighth digit of
the second input screen.)
LZ51-H used?
For individual input:
1st axis output (A/B phase)
For AUTO input:
• • • • • • • 1
Setting unnecessary
Output signal is 1st axis
A/B phase?
(No)
(Yes)
(No)
(Yes)
(Yes)
(No)
(Initial value)
(Initial value)