9 Technical data
110 SOREDEX
206718 rev 9
Table 1.3 RF immunity of non-life-support equipment or
system IEC 60601-1-2
CRANEX 3D is suitable for use in the specified electromagnetic environment. The purchas-
er or user of CRANEX 3D should assure that it is used in an electromagnetic environment
as described below:
Immunity
Test
IEC
60601-1-2
Test Level
Compliance
Level
Electromagnetic
Environment
Conducted
RF IEC
61000-4-6
Radiated
RFIEC
61000-4-3
3 V150 kHz
to80 MHz
3 V/m80
MHz to2,5
GHz
[ V1 ] 3 V
[ E1 ] 3 V/m
Portable and mobile RF communications equipment
are used no closer to any part of CRANEX 3D,
including cables, than the recommended separation
distance calculated from the equation appropriate for
the frequency of the transmitter.
Recommended Separation Distance:
80 MHz to 800 MHz
800 MHz to 2,5 GHz
Where P is the maximum output power rating of the
transmitter in watts (W) according to the transmitter
manufacturer and d is the recommended separation
distance in meters (m).Field strengths from fixed RF
transmitters, as determined by an electromagnetic
site survey,* are less than the compliance level in
each frequency range.** Interference may occur in
the vicinity of equipment marked with the following
symbol:
*Field strengths from fixed transmitters, such as base stations for cellular telephones and land
mobile radios, amateur radio, AM and FM radio broadcast, and TV broadcast cannot be estimated
accurately. To assess the electromagnetic environment due to fixed RF transmitters, an
electromagnetic site survey should be performed. If the measured field strength exceeds the RF
compliance level above, observe CRANEX 3D to verify normal operation in each use location. If
abnormal performance is observed, additional measures may be necessary, such as re-orienting
or relocating CRANEX 3D.
**Over the frequency range 150 kHz to 80 MHz, field strengths are less than [V1] V/m.The
Recommended Separation Distances are listed in the next table.Note: These guidelines may
not apply in all situations. Electromagnetic propagation is affected by absorption and reflection
from structures, objects, and people.