SPACE s.r.l.
Soc.a socio unico
PFB035 SERIES – PFB040 SERIES
PFB045 SERIES – PFB060 SERIES
SPRT102/4 SERIES – SPRT102/5 SERIES
SPRT102/6 SERIES – SPRT102/7 SERIES
Code M0247 - Ver.1.4
(09/2016)
SPACE s.r.l. – 10090 TRANA (TO) Via Sangano, 48
Tel. (+39) 011/ 934 40 300 – Fax (+39) 011/ 933 88 64
e-mail: info@spacetest.it - www.spacetest.com
3.2. Console PFC750E000
All brake tester and suspension tester operations expect the use of a console, featuring electronic
and electric components for the processing and management of signals from the tester sensors.
Figure 7
IMPORTANT!: The rear door leading to the switchboard and the front panel leading to the CPU
board and power board can only be opened by authorized personnel; these
compartments contain high-voltage components which can prove hazardous to
unskilled operators.
1) Monitor for displaying the choice
and sequence of test stages, initial
setting, real-time display of the test
and of the results; monitor size 19”.
Correct luminosity and contrast are
factory set.
2) 102-key PC type keyboard
4) Remote-control infrared receiver
8) Main switch/emergency device
(in the backside)
5) Printer housed behind the central door.
The test results are printed on an ink jet
printer for A4 format sheets.
.
7) On the front is a panel with a lock to key.
Inside the door is a shelf with the CPU board
for managing the signals from the different
measurement devices and the power
supply board.
6) Pictograms affixed to the machine:
Shock hazard
9) On the rear is a door with a lock to key
on which the main switch is present, (part.
8) Inside of which the switchboard is
housed for the powering of the entire
system and the starter of the motors.
3) Roller stop button. Once this has been
pressed, to reset operation, it must be
turned clockwise.
10) An IBM compatible PC can be
accessed featuring HD, an SVGA
graphic card, an RS232 serial port
To Next Page