SPACE s.r.l.
Soc.a socio unico
PFB035 SERIES – PFB040 SERIES
PFB045 SERIES – PFB060 SERIES
SPRT102/4 SERIES – SPRT102/5 SERIES
SPRT102/6 SERIES – SPRT102/7 SERIES
Code M0247 - Ver.1.4
(09/2016)
SPACE s.r.l. – 10090 TRANA (TO) Via Sangano, 48
Tel. (+39) 011/ 934 40 300 – Fax (+39) 011/ 933 88 64
e-mail: info@spacetest.it - www.spacetest.com
7.2. Side slip procedure
The side-slip test indicates vehicle side slip expressed in meters over a distance of one kilometer.
Cross the side-slip test plate very slowly (max 2 km/h), at right angles to the plate without holding
the driving wheel.
The slip plate, crossed over by the left wheel, moves in a direction opposite to the sum of wheel
slip (the right wheel touches the ground and is added to that of the left wheel).
Once the plate has been crossed over, the side-slip reading (see Figure 45) is automatically
displayed after the vehicle axle has reached the next device (adherence test or brake test).
The crossing of the plate can also be manually confirmed by means of the ENTER/F3 key.
The result of the side-slip test is displayed for a few seconds. The operator can press the F2 key
to prevent automatic storage of the test and then store this manually by means of the ENTER/F3
key.
To repeat the side-slip test, the vehicle must be reversed, the START/F4 key must be pressed and
then the slip plate must be crossed again.
Figure 45
Prevents automatic storage of
test
To Next Page