SPACE s.r.l.
Soc.a socio unico
PFB035 SERIES – PFB040 SERIES
PFB045 SERIES – PFB060 SERIES
SPRT102/4 SERIES – SPRT102/5 SERIES
SPRT102/6 SERIES – SPRT102/7 SERIES
Code M0247 - Ver.1.4
(09/2016)
SPACE s.r.l. – 10090 TRANA (TO) Via Sangano, 48
Tel. (+39) 011/ 934 40 300 – Fax (+39) 011/ 933 88 64
e-mail: info@spacetest.it - www.spacetest.com
1. INTENDED USE
The product is designed to perform braking tests on front and rear axles of vehicles weighing under
4000 kg when fully loaded.
The model featuring adherence test device is designed to perform tests on the front and rear axles
of vehicles weighing under 4000 kg when fully loaded.
The max acceptable roller assembly and suspension test load per axle is 2500 daN.
Important! Failure to comply with the weight restrictions indicated above could
permanently damage system parts.
Any damage ensuing from failure to comply with the instructions given in this manual or incorrect
machine use shall relieve SPACE S.R.L. of all liability.
2. PERSONNEL TRAINING
The machine must only be used by specially trained and authorized persons. To ensure the
machine is operated in the best possible manner and measurements are properly made, operators
must be correctly trained and be in possession of all necessary information in order to achieve
operating standards in line with the indications provided by the manufacturer. In case of any
doubt concerning use and maintenance of the machine, refer to the instruction manual; if doubts
still remain, contact an authorized after-sales center or the SPACE S.R.L. technical department.
2.1. General preventive measures
During operation and maintenance of this machine, always abide by the safety and
accident-prevention regulations in force.
The machine must only be used by adequately trained and authorized persons.
This machine must only be used for the purpose for which it was expressly intended.
SPACE S.R.L. declines all liability for injury or damage to persons, animals and things
caused by improper machine use.
Accessories and spare parts must be fitted by persons authorized by SPACE S.R.L. and
only original spare parts and accessories must be used
The machine must only be operated in places where there is no danger of explosions or
fire.
Removal or changes made to safety devices, or warning signals on the machine can cause
serious hazards and represents a violation of European safety regulations.
Before doing any maintenance jobs on the system, always disconnect the power supply.
In case of doubt, do not interpret, but contact SPACE S.R.L. technical assistance in order
to obtain instructions suitable for performing operations in total safety.
Do not allow unauthorized personnel to come near the brake tester during the cycle.
Only one operator must work inside the test area and must not exit from the vehicle near
the roller tester. In the event of the operator, for any reason, not being able to exit from
the vehicle, he should ask for the assistance of a second operator who may access the
test area only after operating the emergency device
The workspace must be clean and dry with particular reference to substances made up
of that oil can cause danger; the atmosphere must sufficiently be illuminated.
To Next Page
Loading...