Chapter 8 : Locations
8-4 Lasair® Pro Aerosol Particle Counter Operations Manual
5. Press again, and select Room as the Item type.
6. From the Parent item dropdown, select your previously created Area to assign the
area to the room.
7. Press OK to confirm your selection.
8. Press
again, and select Location as the Item type.
9. From the Parent item dropdown, select your previously created Room to assign
the location to the room.
NOTE: Note the Parent item will include both the room and its associated area.
Adding Multiple Areas, Rooms, and Locations
1. Go to
> (LOCATIONS).
2. In the Type dropdown, select the option you intend to multiply. For the quickest
assignment, first select the largest Parent item you wish to use: Area > Room >
Location.
NOTE: If you do not intend to assign locations to rooms, or rooms to areas, skip to
step 3 and finish with step 5. Choose Location from the Type dropdown.
3. Press
.
To Next Page
