Spektrum ix20 - To Add a Servo Output Model Start Warning

To add a servo output model start warning:
1. From Model Setup, touch Model Start Warnings.
2. Select the SERVO OUTPUT trigger type.
3. Touch the + icon to add a new warning. Touch the (
), if available, to remove a current warning.
4. Select the desired output channel from the rst drop down button.
5. Select Over or Under from the next drop
down button to dene which side of the
given output position the warning will trigger.
6. Dene the trigger point value. Values from
-100 to 100 may be entered.
7. Select the type of warning and enter text-to-
speech if Voice is selected.