Aileron to Flap (AIL > FLP)
The Aileron to Flap mix allows the entire trailing edge of the wing (aileron and ap) to operate
as ailerons. When active, as aileron is applied, the aps also move. Always program the aps to
move in the same direction as the turn (right aileron input moves the aps as right ailerons).
Elevator to Flap (ELE > FLP)
Elevator to Flap mix creates additional lift, allowing a tighter turn. The entire trailing edge of the
wing (aileron and ap) operates as aps (camber increase) when elevator is applied.
An offset is provided, which is typically used for Snap Flaps. With Snap Flap, no Elevator to Flap
mix occurs until the offset value is reached. Typically, this offset is at 70% up elevator. Beyond
70% up elevator, the down ap mix activates, providing additional lift for aggressive turning
(e.g., in tight thermals or racing turns).