Spektrum ix20 - Binding and Programming Failsafe

BINDING AND PROGRAMMING FAILSAFE
Failsafe is congured when the transmitter and receiver go through the binding process. When
binding an aircraft, always follow these steps to ensure the failsafe operates as expected in the
unlikely event of a loss of radio link:
1. Move the throttle to the low or off position.
2. Set all other controls to the desired failsafe position.
3. Follow the receiver instructions to power the receiver on in bind mode.
4. From the iX20 transmitter Bind menu, touch and hold BIND until the transmitter reports it is
binding.
5. When the transmitter indicates binding was successful, power off the receiver, according to
the receiver instructions.
After the transmitter and receiver are bound, if the radio signal link is ever lost between the
transmitter and receiver, the receiver immediately moves the aircraft control surfaces to the
failsafe positions or holds position depending on the type of failsafe set during bind.
TOC