To adjust travel values:
1. Touch TRAVEL in the ribbon at the top of
the Servo Setup menu.
2. Select the high or low side of the channel.
3. Touch the lock icon (
) to adjust both
directions at the same time, if desired,
or adjust the Low and High values
independently.
4. Make adjustments by sliding the highlighted
circle, touching the + or – buttons.
5. Touch OK to exit back to the main Travel menu.
IMPORTANT: ALT, ROL, PIT and YAW replace THR, AIL, ELE and RUD labels respectively in
multirotor to more closely reect the ight axis of multirotor aircraft.
To Next Page
Loading...
