Spirent communications SmartBits 600x - Appendix D: Serial Port and Telnet Commands

Appendix B: Cable Information
XAUI Extender Module RJ-45 Pinouts
112 | SmartBits 600x/6000x Installation Guide
XAUI Extender Module RJ-45 Pinouts
XLW-3720A and XLW-3721A modules
SmartBits-to-GPS/CDMA Control Interface
The serial (AUX) port on the rear panel of the SmartBits is used to configure the ETR
receiver and to read the clock (yy:mm:dd:hh:mm:ss). The serial port on the SmartBits is
DCE, with pinouts as described below.
Note: Refer to the appropriate user manual for the Interface Kit you are using for the
cable information pertaining to that kit.
Table B-6. XAUI RJ-45 Connector Pin Assignments
Pin Signal Input/Output Voltage
1 LASI Output Active High
2 MDIO Input/Output 1.2v
3 MDC Output 1.2v
4 XENPAK reset Output Active Low
5, 6, 7, 8 Tied together N/A Ground
SmartBits (DCE
RS-232 (9-pin)
TXD
RXD
GND
2
3
5
DB9P DB9S
Male Female
Chassis Cable
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com