Chapter 2: Installation and Setup
Procedure 6: Connect the SmartBits Power Cord
38 | SmartBits 600x/6000x Installation Guide
Procedure 6: Connect the SmartBits Power Cord
Before establishing actual SmartBits-to-PC communication, you need to connect the
power cord to the SmartBits back panel and then activate power. Based on your order, your
shipment will contain either a standard 110 AC power cord (USA), or an international 220
AC power cord (either for Continental Europe or the United Kingdom). (Other locations
may require a customer-provided cable or adapter.
To connect the power cord and activate power:
1 Plug the female end of the power cord into the power cord connector on the back of
the SmartBits chassis.
2 Plug the other end of the power cord into the electrical outlet.
3 Activate power by switching the SmartBits chassis power switch to ON ( I ).
Procedure 7: Start SmartWindow
Once SmartWindow is installed (see “Procedure 3: Install SmartBits Applications” on
page 32), you can launch the program in two ways:
• Double-click on the SmartWindow icon on your desktop.
• Use the Start button on the task bar. Select Start > Programs > SmartBits Systems
Applications > SmartWindow.
Note: The information contained in this procedure only describes the basic start-up
information when using a SmartBits chassis and SmartWindow. For a complete
description of SmartWindow configuration and other options, refer to the SmartWindow
User Guide or the SmartWindow online Help.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...