Appendix D: Serial Port and Telnet Commands
Serial Command Interface Updates
SmartBits 600x/6000x Installation Guide | 121
Serial Command Interface Updates
Starting with firmware version 2.00, the SmartBits 600x/6000x chassis serial command
interface has been enhanced to improve the basic user/card management command
structures and by adding Netmask and Gateway commands. The Netmask and Gateway
commands listed in this appendix are for 2.00 or later firmware releases.
Most of the command structure changes will define and support commands in more of a
hierarchical fashion. In most commands, the order of the command name and first
argument can be swapped; in some cases, this may make the alternate command form
more intuitive command and easier to remember.
The Help command has been updated to reflect the new commands and hierarchical
command structure.
Serial Port Command Set
The following commands apply to all chassis unless otherwise specified.
HELP – Displays the available commands.
VER – Displays the chassis firmware version.
HISTORY – Displays the previous 16 commands.
!! [#] – Recalls any of the previous 16 commands displayed and executes them again.
IPADDR [xxx.xxx.xxx.xxx] – Displays [or modifies] IP address. This command allows
you to change the SmartBits IP address. The change takes effect following a power cycle
or reset. If a new IP address is not entered, the SmartBits will display the current IP
address. If the IP address or the syntax is bad, it will display the following error message:
Invalid IP address entered.
NETMASK – See “Netmask Commands” on page 124.
GATEWAY – See “Gateway Commands” on page 125.
PORTNO [xxxxx] – Displays or modifies the TCP port number for the SmartBits chassis.
IDLEMAX [x] – Displays [or modifies] idle logout time, in seconds (60 seconds to a
maximum of 604800 seconds). This command sets a time limit for the SmartBits
controller to close any inactive open connection. The SmartBits controller has been
designed to be a high-performance multi-user system. Any user who connects to the
controller but does not use it (i.e., does not send any command) will be disconnected and
all resources freed after the set idle time limit expires.
If a new idle time limit value is not entered, the SmartBits controller will display the
current idle time limit value. The largest value for the idle_time_limit_value that is
accepted is 604800.
MACADDR – Displays the SmartBits MAC address. For information only.
SERNUM – Displays the SmartBits serial number. For information only.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...