Spirent communications SmartBits 600x - Setting the IP Address Via Telnet

To Next Page

To Previous Page

Chapter 2: Installation and Setup

Procedure 8: Set the IP Address

SmartBits 600x/6000x Installation Guide | 47

Setting the IP Address via Telnet

Telnet uses the same commands that are available on the console port and provides a

means for Spirent’s Customer Support group to access a customer’s SmartBits chassis for

troubleshooting. In the following example we are using a SmartBits 600x chassis.

To set the IP Address via Telnet:

1 Start a telnet session on your PC or workstation using your preferred Telnet Interface

software.

2 Connect to the SmartBits 600x chassis by providing the chassis default IP address

(192.168.0.100) to the Telnet software. You should see the following prompt:

SmartBits SMB-600 Chassis

3 At the prompt, type:

4 Once connected, you should see the same command prompt, “>>”, as if you are

connected over the console port.

5 Follow steps 10 through 13 on page 46.

6 To disconnect from the chassis, type:

quit <enter>

Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com